How to select compressor for task: pressure, flow, drive

Stepwise view: What is the parameters for starting a rotary screw compressor, how not to overpay for extra power and why it's more important than it looks.

The error in selecting the compressor is expensive: under-expenditure stops production, over-takes — For years, it burns an extra kilowatt. We're going to figure out how to get the right model in four steps and what data to prepare before talking to the supplier.

Step 1. Working pressure

Send point — The pressure that your most demanding consumer needs. For most pneumatic tools tools and workshop tasks, this is 7–8 bar, for laser cutting by nitrogen or special processes — See above. There is no need to put a "just in case" reserve: every extra bar outside — That's about 6–7 % of the energy overrun.

Between compressor and consumption point is lost 0,5–1 The bar on the drain, filters and the mains. If the tool needs 6 bar — Compressor adjusted 7–7,5 bar, not at 10.

Step 2. Productivity (air)

The consumption is considered in m³/min for the actual consumption of all simultaneously operating consumers plus 15–25 % leak and perspective. This is the most frequent source of error: the passport costs of the tool are added without the co-ordinate factor, over-rated and taken up the compressor "for growth", which then works in the blank.

Step 3. Type of transmission and regulation

A compressor with a direct drive and a load/cold stroke is economical for constant flat load. The variable consumption (shifts, peak selection) pays off the frequency drive (in the case of a change in consumption).VSD) it keeps the pressure narrow and reduces energy consumption by 20–35 % on the job just under current air-scrapping.

Step 4. Air preparation and operating conditions

Compressor — It's half the system. The task is immediately to select the resistors, dryers and filters of the appropriate purity class, and also to take into account room temperature, dust and ventilation. For paint and pneumatics, the dryer and oil filtering are critical for sands. — productivity and cooling.

List of consumers with flow and pressure, operating mode (hours per day), air purity requirements, temperature and space. From this data, we'll pick up the compressor and the whole bandage to a task.

Send Options — We'll prepare a selection, binding and commercial offer.

SHELFTEKHPROEKT
SHELFTEKHPROEKT
Industrial equipment
Русский Request a quote
{{ typeLabel }}

{{ title }}

SAnswer: Shelftekhproekt engineer Question: {{ author }}
Customer question

{{ question }}

S
SHELFTEHPROEKT answer

{{ p.text }}

What we clarify before quoting

  • {{ c.text }}

Typical mistakes and risks

  • ✕{{ m.text }}
Lead time

{{ timeframe }}

Documents and terms

{{ documents }}

Commercial summary

{{ conclusion }}

{{ b.text }}

{{ b.text }}

{{ b.text }}

  • {{ it.text }}
{{ s.n }}
{{ s.h }}
{{ s.text }}
{{ b.title }}
{{ b.text }}
{{ h.v }}
{{ c.v }}
Next step

{{ cta }}

#{{ t.text }}
No publication found

Go back to the knowledge base or ask the engineer directly.

To the knowledge base